- Introduction:QL- Silicone-based Waterproof Repellents (Liquid Type) is a colourless, transparent, solvent-based protective agent. It can form a long-lasting protective layer on the surface of a stone, preventing water and pollutant from penetrating into it.
It has excellent acid and alkali resistance, thus can effectively prevent water stains, various chemical reactions such as salt fractionation, efflorescence (flower out) and yellowing.
- Product Features:
1. Water-based, environmentally-friendly, colourless and transparent, good penetration depth;
2. High durability, no sticky to hand after curing;
3. It produces hydrophobic effect rapidly;
4. It will not block the capillary pores of the substrate or obstruct it from “breathing”.
5. Quick form a water-drop effect.
- Application Range:
1. Applicable to all kinds of concrete, mineral plasters, cement fibre boards, sand - lime brick masonries, aerated concretes, mineral-based natural stones and artificial stones, inorganic coating;
2. Waterproofing and protection of all kinds of concrete, ceramic tiles, paints, exterior wall coatings, GRC and other cement products.
Application Methods:
1. The base for spraying must be firm, clean and free of dust. Small pores, sand holes and cracks must be fixed and smoothened beforehand;
2. Apply the protective agent to the base surface with a spray or brush. Before the first coating is completely dried, spray or brush the product again (wet-on-wet spraying method). It is recommended to apply the agent for more than two times to achieve the desired effect;
3. The waterproofing agent that accumulates on the base or ceramic tile surface should be cleaned with a dry cloth or sponge immediately;
4. The quality used for spraying twice: 0.1kg~0.2kg/㎡, the actual quality used depends on the compactness of the base material.
Recommended Tools:
Brush, spatula, float trowel, electronic mixer, mixing bucket
1. The base for spraying must be firm, clean and free of dust. Small pores, sand holes and cracks must be fixed and smoothened beforehand;
2. Apply the protective agent to the base surface with a spray or brush. Before the first coating is completely dried, spray or brush the product again (wet-on-wet spraying method). It is recommended to apply the agent for more than two times to achieve the desired effect;
3. The waterproofing agent that accumulates on the base or ceramic tile surface should be cleaned with a dry cloth or sponge immediately;
4. The quality used for spraying twice: 0.1kg~0.2kg/㎡, the actual quality used depends on the compactness of the base material.
Recommended Tools:
Brush, spatula, float trowel, electronic mixer, mixing bucket
- Technical Indicators:
Experimental Project Technical Specifications (%)
Solid Content≥5% PH Value 7 Stability No Oil, No Layer Water Absorption Ratio ≤20
