- Introduction:QL- Exterior Wall Transparent Waterproof Coating is a flexible, transparent and colourless polymer product, which is produced by combining special polymer emulsion, styrene-butadiene rubber polymer modifier, surfactant and plasticizer
- Product Features:
1. Colourless and transparent; it will not ruin the original decorative effect after coating; not easy to turn yellow or be stained with dust.
2. Excellent resistance to heat, ultraviolet rays, ozone, acid and alkali; great adaptation to temperature.
3. Excellent film formation, soft and tough.
4. Using water as a dispersion medium; non-toxic, harmless, non-polluting, it is an environmentally-friendly product.
5. Supporting cold application, it is easy to use and can be applied by brushing, rolling, spraying, scraping to the walls.
6. The firm-forming has micro-porous permeability, which is suitable for thermal evaporation in a humid climate in the south; and won’t be agitated.
7. Low dosage and low cost.
- Application Range:
1. Suitable for waterproofing repair of exterior wall leakage of various buildings.
2. Suitable for waterproofing applied to the interface of various decorative coating materials.
3. Waterproofing and moisture-proof on the surface of exterior wall decorative materials.
Application Methods:
1. Use detergent, wire brush and cloth to clean the base of the wall as much as possible, but try not to destroy the original surface lustre.
2. Paint the transparent waterproof coating on the wall with a brush. The joints of decorative tiles should be carefully brushed, about 2-3 times in general. When brushing, apply a new coating on top of the other when the previous layer no longing stick to hands, and the direction of brushing should be crisscross-cutting.
3. During the construction process, if the sealant is too high, water can be added, but the amount of water should be as little as possible.
4. Reference consumption: 0.1～0.2mm thick (0.1～0.2kg/㎡)
Recommended Tools:
Brush, spatula, float trowel, electronic mixer, mixing bucket
1. Use detergent, wire brush and cloth to clean the base of the wall as much as possible, but try not to destroy the original surface lustre.
2. Paint the transparent waterproof coating on the wall with a brush. The joints of decorative tiles should be carefully brushed, about 2-3 times in general. When brushing, apply a new coating on top of the other when the previous layer no longing stick to hands, and the direction of brushing should be crisscross-cutting.
3. During the construction process, if the sealant is too high, water can be added, but the amount of water should be as little as possible.
4. Reference consumption: 0.1～0.2mm thick (0.1～0.2kg/㎡)
Recommended Tools:
Brush, spatula, float trowel, electronic mixer, mixing bucket
- Technical Indicators:
Experimental Project Technical Specifications Exterior Transparent Solid Content 50+2% Heat Resistance 80+ 2°C, 5h Low-temperature Flexibility -20 °C,Pass Elongation ≥400% Tensile strength at break 0.4-0.8MPa
