- Introduction:QL- Roofing Waterproof Coating (weather-resistant and decorative type) is a single-component water-based waterproof coating. It is produced by combining acrylic emulsion with other additives using foreign advanced technologies and materials.
- Product Features:
1. Using water as a dispersion medium; non-toxic, ordorless, non-polluting, it is an environmental-friendly product;
2. Single component, cold application, it can be applied by brushing, rolling, spraying, scraping etc.;
3. Excellent resistance to aging, elongation, elasticity, adhesion and firm formation;
4. The waterproof layer is a closed system with overall good waterproof effect, especially suitable for the application of special-shaped structural base layer;
5. Can be used as a colour protective layer for the black waterproof layer of rubberized asphalt to achieve beautifying effect.
- Application Range:
1. Suitable for waterproofing and heat insulation of short-term water-immersed areas such as metal roofing;
2. Especially suitable for roof waterproofing of thin-shell structures. It can also be used as adhesive or exterior wall decorative coating;
3. Suitable for waterproofing and decoration of old roofs.
Application Methods:
1. Base surface preparation: The base surface must be flat, firm, clean, no water and osmosis, dents, cracks and leakage must be fixed first, internal and external corners to be made round.
2. Coating:
a. Apply it with a roller or brush;
b. The coating (especially the primer) should be constantly stirred even when in use;
c. The coating should be applied evenly without precipitation;
d. Apply a new coating on top of the other when the previous layer is not sticky to hand;
e. Each layer must be coated according to the specified quality. It should not be too thick or too thin;
f. Use the non-woven fabric to strengthen smaller parts. After applying the first layer, paste the non-woven fabric without using water; thereafter apply the second and third layers.
3. Recommended Amount: 1.5～2.0mm thick (1.5～2.0kg/㎡)
1. Base surface preparation: The base surface must be flat, firm, clean, no water and osmosis, dents, cracks and leakage must be fixed first, internal and external corners to be made round.
2. Coating:
a. Apply it with a roller or brush;
b. The coating (especially the primer) should be constantly stirred even when in use;
c. The coating should be applied evenly without precipitation;
d. Apply a new coating on top of the other when the previous layer is not sticky to hand;
e. Each layer must be coated according to the specified quality. It should not be too thick or too thin;
f. Use the non-woven fabric to strengthen smaller parts. After applying the first layer, paste the non-woven fabric without using water; thereafter apply the second and third layers.
3. Recommended Amount: 1.5～2.0mm thick (1.5～2.0kg/㎡)
Recommended Tools:
Brush, spatula, float trowel, electronic mixer, mixing bucket
- Technical Indicators：
Experimental Project Technical Specifications (MPa)
Compressive Strength1.0
Solid Content≥65 (%)
Elongation at Break≥300 (₵10mm)
Low-temperature Flexibility≥ -10 °C, No Cracks (0.3MPa, 0.5h)
Impervious to WaterImpervious to Water
